Helps prevent discolouration of swimming pool surfaces by disolved metals including Iron, Copper, Manganese & Calcium.
Active Constituents: 200g/Kg Sodium EDTA and blended food grade chelating agents.
STEP 1 Stop swimming and adjust the pH to neutral 7.0 then backwash or clean the pool filter and then turn the pool pump off. Remove all plastic parts including pool covers, hoses, automatic pool cleaners, etc. Allow the free chlorine to drop to zero before treatment for best results.
STEP 2 For recent stains in swimming pools, add 250 g of SERIOUSTAIN (TM) REMOVER per 10,000 litres of water dissolved in 10 litres of water and pour around edges. In spas add 100g per 2,000 litres. Brush the walls and floor and after 24 hours if the stains have faded restore the pH to 7.2 with a similar quantity of sodium bicarbonate. If staining persists after 24 hours go to step three before restoring the pH.
STEP 3 For severe or old stains in swimming pools, add 500 g of SERIOUSTAIN (TM) REMOVERper 10,000 litres of water dissolved in 10 litres of water and pour around edges. Additional hydrochloric acid may be added to further lower the pH and shift more stubborn alkaline deposits (refer Precautions below). Vinyl lined pools add 500mls per 10,000 litres, fibreglass pools add 1000 ml per 10,000 litres, concrete pools add 2000 ml per 10,000 litres of pool water. For painted concrete pools in good condition, use the dose as for fibreglass.
STEP 4 Once all stains have faded, turn on pump and filter and add 2 Kg doses of sodium bicarbonate morning and night, testing the pH between applications until the pH is restored to the ideal 7.2. As a guide, around 1 Kg of sodium bicarbonate is required for every 1 Kg of SERIOUSTAIN (TM) REMOVERor hydrochloric acid used in the treatment.
STEP 5 After the above treatment for mineral staining, it is good practice to dump a third of the pool water and replace with fresh fill water, which dilutes the mineral loading of the pool water by one third. Always add one bottle of POOL STAIN INHIBITOR to chemically complex remaining minerals in solution and prevent stains returning.
STEP 6 Restore the free chlorine level to 1.5 ppm and maintain the pH in the correct 7.2 to 7.6 range by testing the water weekly which is vital to ensuring the effectiveness of all pool chemicals, especially chlorine as a sanitiser. We recommend the use of liquid chlorine or a salt water chlorinator to sanitise pool water as calcium based chlorine builds excess hardness and causes cloudy water. Use only sodium bicarbonate to increase pH in swimming pools and spas as sodium carbonate (soda ash) is too alkaline and does not buffer pH. Add our POOL STAIN INHIBITOR once a season to neutralise future mineral staining before it occurs.